Starting Temperature Control Procedure
  1. Press “Setup” from the front panel
  2. Click on the “Device Parameters” tab
  3. Enter the desired temperature in “Run Temp” (represented in degrees centigrade)
  4. Ensure that the RTD1 and RTD2 values match the provided values for the Tempe
  5. Click “Update Parameters”
  6. Press the "Update Parameters" button
  7. Click “Finish” to return to the front panel
  8. Click “Temp CTRL” to start the process

This process will take about 10 minutes to stabilize depending on the set “Run Temp”. The system is
now automatically setting the temperature. To cancel the temperature control process, click
“Temp Ctrl” again. The heater power will now return.