- Plug in the Eon™ and all of its components
- Open on the Eon™ software and select the correct COM port
- Select the material and make sure the density and Z-Factor are correct and save layer
- Switch to the “Device Parameters” tab
- Select the correct crystal frequency and tooling factor and name the log file, alpha values and filter
- Press the "Update Parameters" button
- Press "Finish" when all changes are saved
Getting started with Eon™ Print
Modified on: Wed, 14 May, 2014 at 2:08 PM
Did you find it helpful? Yes No
Send feedbackSorry we couldn't be helpful. Help us improve this article with your feedback.